Texture Roller - Vampire

Texture Roller - Vampire

Texture rollers designed to emboss a permanent, repeatable pattern onto clay and other putties. Made from clear, non-toxic PMMA plastic with amazing non-piercing properties. The texture rollers are available in several different textures, depending on your specific needs.

Length: 14.50 cm (5.5 inches)
Diameter: 2.5 cm (1 inch)

INSTRUCTIONS FOR USE:
1. - Mix the putty/clay/modeling paste correctly until it is ready according to the manufacturer's recommendations.
2. - Spread out the putty/clay/modeling paste. For better results, smooth the material. We recommend using a flat, untextured rolling pin for this purpose.
3. - Depending on the type of material, we recommend moistening the roller to prevent it from sticking.
4. - Move the roller with consistently even pressure to ensure a continuous texture.
5. - Cut off the excess material at the sides with a sharp knife. We recommend letting the material dry beforehand.

MATERIALS:
There are many different putties and types of clay on the market, and all can be textured with the right technique.
Modeling with these rollers and polymer clay (Fimo or Sculpey type) is usually quite easy, as polymer clay allows for easy error correction due to the heat required for curing.
If the goal is to model textured bases, we recommend using MDF wood bases. It is possible to texture the material directly on the bases and then fire the model, including the MDF wood bases, in the oven at 150ºC for 15 minutes. The MDF wood bases will not burn and will subtly remind you of the smell of toasted bread.
In the case of epoxy putties, there are various techniques to achieve similar results. The advantage of these materials is that they do not need to be fired but can be textured directly.
When using Green Stuff, which is particularly sticky, it is advisable to moisten the surface of the roller or the material with a little water before embossing the texture.
Also, talcum powder or even directly applied modeling petroleum jelly (LINK) can reduce the stickiness of the Green Stuff.
Other epoxy putties, e.g., Milliput modeling compounds, can also be used. However, these should not be moistened, as it unnecessarily complicates the work. If Milliput appears too sticky, the material should be kneaded until the stickiness subsides.

CLEANING AND CARE:
After using the roller, it should be cleaned with a scratching brush and plenty of water to remove any residue of the material used.

SAFETY:
Children should always be supervised by an adult when in use.