Textured Rolling Pin - Runes

Textured Rolling Pin - Runes

Textured rolling pins used to impress a permanent repeating pattern onto clay and other putties. Made from transparent, non-toxic PMMA plastic with amazing non-piercing properties. The textured rolling pins are available in several different textures, depending on your specific needs.

Length: 14.50 cm (5.5 inches)
Diameter: 2.5 cm (1 inch)

INSTRUCTIONS FOR USE:
1. - Mix the putty/clay/modeling compound correctly until it is ready according to the manufacturer's recommendations.
2. - Spread out the putty/clay/modeling compound. For better results, smooth the compound. We recommend using a flat rolling pin, without texture, for this purpose.
3. - Depending on the type of material, we recommend moistening the rolling pin to prevent sticking.
4. - Move the rolling pin with pointwise even pressure to ensure a continuous texture.
5. - Cut off excess material on the sides with a sharp knife. We recommend letting the material dry beforehand.

MATERIALS:
There are many different putties and types of clay on the market, and all can be textured with the right technique.
Modeling with these rolling pins and polymer clay (Fimo or Sculpey type) is usually quite easy, as polymer clay allows for easy error correction due to the heat required for curing.
If the goal is to model textured bases, we recommend using MDF wood bases. It is possible to texture the material directly on the bases and then bake the model, including the MDF wood bases, in the oven at 150ºC for 15 minutes. The MDF wood bases will not burn and will lightly resemble the smell of toast.
In the case of epoxy putties, there are different techniques to achieve similar results. The advantage with these materials is that they do not need to be baked but can be textured directly.
When using Green Stuff, which is particularly sticky, it is advisable to moisten the surface of the rolling pin or the compound with a little water before impressing the texture.
Also, talcum powder, or even directly applied modeling vaseline (LINK), can reduce the stickiness of the Green Stuff.
Other epoxy putties, e.g., Milliput modeling compounds, can also be used. However, these should not be moistened, as it unnecessarily complicates the work. If Milliput appears too sticky, the compound should be kneaded until the stickiness subsides.

CLEANING AND CARE:
After using the rolling pin, it should be cleaned with a scratching brush and plenty of water to remove any residue of the material used.

SAFETY:
Children should always be in the presence of an adult when using.