Texture Roller - Grid

Texture Roller - Grid

Texture rollers designed to emboss a permanent, repeated pattern onto clay and other putties. Made from transparent, non-toxic PMMA plastic with amazing non-stick properties. Texture rollers are available in several different textures, depending on your specific needs.

Length: 14.50 cm (5.5 inches)
Diameter: 2.5cm (1 inch)

INSTRUCTIONS FOR USE:
1. - Mix the putty/clay/modeling paste correctly until it is ready according to the manufacturer's recommendations.
2. - Spread the putty/clay/modeling paste. For best results, smooth the paste. We recommend using a flat, untextured rolling pin for this purpose.
3. - Depending on the type of material, we recommend moistening the roller to prevent it from sticking.
4. - Move the roller with uniform, intermittent pressure to ensure a continuous texture.
5. - Cut off excess material at the sides with a sharp knife. We recommend letting the material dry beforehand.

MATERIALS:
There are many different putties and types of clay on the market, and all can be textured with the right technique.
Modeling with these rolling pins and polymer clay (Fimo or Sculpey type) is usually quite easy, as polymer clay allows for easy error correction due to the heat required for curing.
If the goal is to model textured bases, we recommend using MDF wood bases. It is possible to texture the material directly on the bases and then bake the model, including the MDF wood bases, in the oven at 150ºC for 15 minutes. The MDF wood bases will not burn and will have a slight smell reminiscent of toast.
In the case of epoxy putties, there are different techniques to achieve similar results. The advantage of these materials is that they do not need to be fired, but can be textured directly.
When using Green Stuff, which is particularly sticky, it is advisable to moisten the surface of the roller or the paste with a little water before impressing the texture.
Also, talcum powder, or even directly applied modeling vaseline (LINK), can reduce the stickiness of Green Stuff.
Other epoxy putties, e.g., Milliput modeling pastes, can also be used. However, these should not be moistened, as this unnecessarily complicates the work. If Milliput appears too sticky, the paste should be kneaded until the stickiness subsides.

CLEANING AND CARE:
After using the roller, it should be cleaned with a scratching brush and plenty of water to remove any residue of the material used.

SAFETY:
Children should always be in the presence of an adult when using.