Textured Roller - Chinese

Textured Roller - Chinese

Textured rollers that can imprint a permanent, repeating pattern onto clay and other putties. Made from clear, non-toxic PMMA plastic with amazing non-piercing properties. The textured rollers come in several different textures, depending on your specific needs.

Length: 14.50 cm (5.5 inches)
Diameter: 2.5 cm (1 inch)

INSTRUCTIONS FOR USE:
1. - Mix the putty/clay/modeling material properly until it is ready according to the manufacturer's recommendations.
2. - Spread out the putty/clay/modeling material. For best results, smooth the material. We recommend using a flat, untextured rolling pin for this purpose.
3. - Depending on the type of material, we recommend moistening the roller to prevent it from sticking to the roller.
4. - Move the roller with consistent, even pressure to ensure a continuous texture.
5. - Cut off the excess material on the sides with a sharp knife. We recommend letting the material dry beforehand.

MATERIALS:
There are many different putties and types of clay on the market, and all can be textured with the right technique.
Modeling with these rolling pins and polymer clay (Fimo or Sculpey type) is usually quite easy, as polymer clay allows for easy error correction due to the heat required for curing.
If the goal is to model textured bases, we recommend using MDF wooden bases. It is possible to texture the material directly onto the bases and then bake the model along with the MDF wooden bases in the oven at 150ºC for 15 minutes. The MDF wooden bases will not burn and will lightly resemble the smell of toast.
In the case of epoxy putties, there are different techniques to achieve similar results. The advantage of these materials is that they do not need to be baked but can be textured directly.
When using Green Stuff, which is particularly sticky, it is advisable to moisten the surface of the roller or the material with a little water before imprinting the texture.
Also, talcum powder, or even directly applied modeling petroleum jelly (LINK), can reduce the stickiness of Green Stuff.
Other epoxy putties, e.g., Milliput modeling material, can also be used. However, these should not be moistened, as it unnecessarily complicates the work. If Milliput appears too sticky, the material should be kneaded until the stickiness subsides.

CLEANING AND CARE:
After using the roller, it should be cleaned with a scratching brush and plenty of water to remove any residue of the material used.

SAFETY:
Children should always be in the presence of an adult when using.